Network
From Hive13 Wiki
Contents |
[edit] Hive Network Infrastructure Installation
We're in the middle of putting in the permanent Hive13 network infrastructure. We will have jacks located in several areas outside the Office/Lab rooms, including along the Internet Bar, the Workbench, the Dirty Room, and eventually along the outside wall of the Office and the general workspace.
[edit] Current Status
- The rack has been set up with one 96 port patch panel and two 24-port switches.
- Wire runs have been installed to the key areas.
- The Internet Bar is finished.
- Some of the Workbench jacks are finished, some are ready to be terminated.
[edit] Work to be Done
- Dress cables w/in rack ahead of termination and punching down.
- Terminate remaining jacks in Office and at Workbench.
[edit] Intended Jacks
- 16 along the Internet Bar.
- 4 on the support column next to the Workbench.
- 10 along the outside wall of the Office.
- 2 inside the Dirty Room.
- 1 on the "Webcam Mount".
[edit] Hive Network Configuration
We're updating the Hive13 network configuration.
[edit] Current Status
- DynDNS at hive13.gotdns.org
- firewall (192.168.1.1)
- server01 (192.168.1.2)
- Linksys AP (192.168.1.253)
- The Westell modem has been connected directly to the Smoothwall firewall's external (red) interface via the patch panel. Port 69. Red cable.
- The Smoothwall has an internal (green) interface. This connects the firewall to the LAN. Yellow cable in port #2.
- The Linksys AP has been placed up on the wiring cabinet and connected, via one of its switch ports, to the LAN. Yellow cable in switch port #1.
- SSH access to server01 has been enabled via hive13.gotdns.org port 2222
- Server01 is running TFTP server for PXE boot
[edit] Work to be Done
- Install / configure netboot images on server01:
- DBAN image
- alternate *ubuntu images.
- UBCD image
- Parted Magic LiveCD image
- Clonezilla image
- ???
- [non-]profit
