Big laser cutter: Difference between revisions
Reportingsjr (talk | contribs) (Added images and description of auto z sensor modification.) |
(Added/updated users) |
||
Line 30: | Line 30: | ||
Fix yet to be done. | Fix yet to be done. | ||
= Users = | |||
The Big Laser is only available to Hive13 members who have been certified on its use & care. To become certified, you need to take the certification class. Contact us about scheduling one at other times. | |||
'''Note: The list of certified people is currently out up to date. Please notify a trainer (listed below) if you were accidentally left off the list''' | |||
Only the following people are certified and permitted to fire the lazzzor: | |||
* Elly Hall | |||
* Ryan Hershey | |||
* Daniel McNamara | |||
* Tiffany Horwath | |||
* Tom Meyer | |||
* Jon Neal | |||
* Bill Steele | |||
'''Trainers''' | |||
* Elly Hall | |||
* Ryan Hershey |
Revision as of 21:20, 5 January 2016
Fab Lab | ||
---|---|---|
3D Printing | 2D Cutting | Misc |
Hive13 Equipment |
---|
List of All Documented Equipment
|
Owner/Loaner: Hive13 |
Hive13 Asset Tag: None |
Make/Model: G.Weike LC1512 (google) |
Arrival Date: 07/2015 |
Does it work?: Yes |
Certification Needed?: yes |
Contact: Fab Lab area warden |
Floorplan: 1A |
![]() |
![]() |
Pages to do with the Laser Cutter: |
Modifications
New auto z zeroing sensor
Replacement sensor is a TL-Q5MC1 inductive sensor. They are commonly available on ebay. We use a 1" aluminum cylinder as our chunk of metal to detect. This is the same setup we use on the smaller Laser Cutter.
The picture on the left show approximately how the new sensor is mounted. The sensor had to be mounted backwards AND the bracket had to be mounted backwards so it is out much further than it needs to be.
The picture on the left shows the wiring for the new sensor. Far left (red) is 24V power, middle is the output signal, far right is ground.
The main thing that needs to be done is a 24V line needs to be run to the new sensor. The other two wires are what was used by the old pen style auto z zeroing sensor.
Counter balancing the lid
The pneumatic cylinders on our laser were bad when we received the laser which cause some near accidents when the lid wasn't supported and came crashing down.
Fix yet to be done.
Users
The Big Laser is only available to Hive13 members who have been certified on its use & care. To become certified, you need to take the certification class. Contact us about scheduling one at other times.
Note: The list of certified people is currently out up to date. Please notify a trainer (listed below) if you were accidentally left off the list
Only the following people are certified and permitted to fire the lazzzor:
- Elly Hall
- Ryan Hershey
- Daniel McNamara
- Tiffany Horwath
- Tom Meyer
- Jon Neal
- Bill Steele
Trainers
- Elly Hall
- Ryan Hershey