Difference between revisions of "Big laser cutter"

From Hive13 Wiki
Jump to navigation Jump to search
(Added/updated users)
(Added picture to the page.)
Line 8: Line 8:
 
|contact=Fab Lab area warden
 
|contact=Fab Lab area warden
 
|where=1A
 
|where=1A
 +
|Image=File:Big Laser 01092016.jpg
 
|certification=yes
 
|certification=yes
 
|subcat=DigitalFabrication
 
|subcat=DigitalFabrication

Revision as of 19:24, 9 January 2016

Fab Lab
3D Printing 2D Cutting Misc



Hive13 Equipment
List of All Documented Equipment
Big Laser 01092016.jpg
Owner/Loaner: Hive13
Hive13 Asset Tag: None
Make/Model: G.Weike LC1512 (google)
Arrival Date: 07/2015
Does it work?: Yes
Certification Needed?: yes
Contact: Fab Lab area warden
Floorplan: 1A
Big_laser_cutter.png



WARNING: Do not look into laser with remaining eye. Pages to do with the Laser Cutter:

Modifications

New auto z zeroing sensor

Replacement sensor is a TL-Q5MC1 inductive sensor. They are commonly available on ebay. We use a 1" aluminum cylinder as our chunk of metal to detect. This is the same setup we use on the smaller Laser Cutter.

new sensor mounted backwards
wiring for new sensor

The picture on the left show approximately how the new sensor is mounted. The sensor had to be mounted backwards AND the bracket had to be mounted backwards so it is out much further than it needs to be.

The picture on the left shows the wiring for the new sensor. Far left (red) is 24V power, middle is the output signal, far right is ground.

The main thing that needs to be done is a 24V line needs to be run to the new sensor. The other two wires are what was used by the old pen style auto z zeroing sensor.

Counter balancing the lid

The pneumatic cylinders on our laser were bad when we received the laser which cause some near accidents when the lid wasn't supported and came crashing down.

Fix yet to be done.

Users

The Big Laser is only available to Hive13 members who have been certified on its use & care. To become certified, you need to take the certification class. Contact us about scheduling one at other times.

Note: The list of certified people is currently out up to date. Please notify a trainer (listed below) if you were accidentally left off the list

Only the following people are certified and permitted to fire the lazzzor:

  • Elly Hall
  • Ryan Hershey
  • Daniel McNamara
  • Tiffany Horwath
  • Tom Meyer
  • Jon Neal
  • Bill Steele

Trainers

  • Elly Hall
  • Ryan Hershey