Delta 3D Printer: Difference between revisions

From Hive13 Wiki
Jump to navigation Jump to search
(Created page with " {{Infobox Project |ProjectTitle=Delta 3D Printer |ProjectImage=Image:Brochure-Hive13-Logo-1200h.png|240px |ProjectStatus=Active |ProjectOwner=Open |ProjectLocation=FabLab |Pr...")
 
(Initial Posting)
Line 1: Line 1:
Observation: The current inventory of arm rods, base plates, hot ends and motors are part of defining the printer geometry. Further design definition is required to document hot end dimensions including center of gravity and mounting in effector. This will constrain minimum effector dimensions. Selection of arm end attachment to effector and carriage (rod ends or magnet-ball) will further constrain the effector design. Using these constraints the effector geometry can be designed to maximize effector stability as defined in the excellent RepRap Delta_Geometry article.


{{Infobox Project
The effector design, defines the arm spacing which is required to define the carriage. Once the column spacing, effector, arms and carriage are roughed out in dimensions the print envelope can be calculated.
 
See RepRap – Delta Geometry   <nowiki>http://reprap.org/wiki/Delta_geometry</nowiki>{{Infobox Project
|ProjectTitle=Delta 3D Printer
|ProjectTitle=Delta 3D Printer
|ProjectImage=Image:Brochure-Hive13-Logo-1200h.png|240px
|ProjectImage=Image:Brochure-Hive13-Logo-1200h.png|240px

Revision as of 14:40, 31 January 2018

Observation: The current inventory of arm rods, base plates, hot ends and motors are part of defining the printer geometry. Further design definition is required to document hot end dimensions including center of gravity and mounting in effector. This will constrain minimum effector dimensions. Selection of arm end attachment to effector and carriage (rod ends or magnet-ball) will further constrain the effector design. Using these constraints the effector geometry can be designed to maximize effector stability as defined in the excellent RepRap Delta_Geometry article.

The effector design, defines the arm spacing which is required to define the carriage. Once the column spacing, effector, arms and carriage are roughed out in dimensions the print envelope can be calculated.

See RepRap – Delta Geometry   http://reprap.org/wiki/Delta_geometry


Hive13 Project
Delta 3D Printer
Brochure-Hive13-Logo-1200h.png
Status: Active
Project Owner: Open
Project Location: FabLab
Where to contribute: We need to complete the design. We will need to design all the printed parts. Print 3D parts.
Start Date: 01/31/2018
End Date: MM/DD/YYYY