Delta 3D Printer: Difference between revisions

From Hive13 Wiki
Jump to navigation Jump to search
(added kinematics ref)
Line 27: Line 27:


= Project Status =
= Project Status =
We are going through the existing parts (motors, carbon tubes, boards, build plates).
We are going through the existing parts (motors, carbon tubes, boards, build plates).


Line 88: Line 89:
= Project Needs =
= Project Needs =
* Finalize design of 3D printed parts (corner blocks, carriage/trolly, hot end holder, arms)
* Finalize design of 3D printed parts (corner blocks, carriage/trolly, hot end holder, arms)
*[[File:Rostock Delta Kinematics by Steve Graves (Johann C. Rochel (Rostock) Style ).pdf|thumb]]Reference - Delta Robot Kinematics by Steve Graves (Johann C. Rochel (Rostock) Style)
* Print the pieces we can
* Print the pieces we can
* Figure out what we need to buy
* Figure out what we need to buy

Revision as of 18:12, 7 February 2018



Hive13 Project
Delta 3D Printer
Brochure-Hive13-Logo-1200h.png
Status: Active
Project Owner: Open
Project Location: FabLab
Where to contribute: Need to complete the design and print 3D parts.
Start Date: 01/31/2018
End Date: MM/DD/YYYY


Overview

Build a Delta 3D printer for the Hive.

Summary

Create a Delta 3D printer from some existing parts and 3D print the remaining parts.

Observation: The current inventory of arm rods, base plates, hot ends and motors are part of defining the printer geometry. Further design definition is required to document hot end dimensions including center of gravity and mounting in effector. This will constrain minimum effector dimensions. Selection of arm end attachment to effector and carriage (rod ends or magnet-ball) will further constrain the effector design. Using these constraints the effector geometry can be designed to maximize effector stability as defined in the excellent RepRap Delta_Geometry article.

The effector design, defines the arm spacing which is required to define the carriage. Once the column spacing, effector, arms and carriage are roughed out in dimensions the print envelope can be calculated.

Project Manager

Brad Walsh

Contributors

  • James
  • Dave

Project Status

We are going through the existing parts (motors, carbon tubes, boards, build plates).

Got approval from the Hive for $250 to spend on parts and stuff.

Inventory of Stuff We Have:

Bar, carbon fiber tube OD 11.93 mm, ID 9.98 mm

·       Qty 46  183 mm long

·       Qty 28  750 mm long

Arm, carbon fiber tube OD 5.83 mm, ID 3.62 mm

·       Qty 30  226 to 229 mm long

·       Qty  6    Same arm with rod end attached

Rod End – Alignment range measured at +/- 37 degrees

·       Qty 60 approximate ( may be missing bearing inserts ) Pressed one together, it works.

Hot End assembly Some with, some without fans – General physical dimensions

Build Plate – 262 mm across minor axis 305 mm across major axis 

Motors

Controller(s)

Hot ends

Miscellaneous

Budget Tracking

Item Description Cost (each) Quantity Cost Remain
Initial Budget 250
Motor purchase ? ? 100 150

Project Needs

Project Updates

January 30, 2018

Brad, James and Dave got together and decided on a triangle frame and two vertical rods per corner.

Links

  • RepRap – Delta Geometry  [1]