Network

Property "ProjectImage" (as page type) with input value "4335907679" contains invalid characters or is incomplete and therefore can cause unexpected results during a query or annotation process.

Hive13 Project
Network Setup
[[<flickr>4335907679|200px]]
Status: InActive
Start Date: 6/29/2009

Hive Network Infrastructure Installation

We're in the middle of putting in the permanent Hive13 network infrastructure. We will have jacks located in several areas outside the Office/Lab rooms, including along the Internet Bar, the Workbench, the Dirty Room, and eventually along the outside wall of the Office and the general workspace.

Current Status

Network Infrastructure:

• The rack has been set up with one 96 port patch panel and two 24-port switches.
• Wire runs have been installed to the key areas.
  • The Internet Bar is finished.
  • Some of the Workbench jacks are finished, some are ready to be terminated.
• 24 Port switch on workbench.

Work to be Done

• Dress cables w/in rack ahead of termination and punching down.
• Terminate remaining jacks in Office and at Workbench.

Intended Jacks

• 16 along the Internet Bar.
• 4 on the support column next to the Workbench.
• 10 along the outside wall of the Office.
• 2 inside the Dirty Room.
• 1 on the "Webcam Mount".

Hive Network Configuration

We're updating the Hive13 network configuration.

Current Status

Paul Reviewed this list as of 12/12/2010 If you make changes to the network, make sure these still function after the changes:

• DynDNS at hive13.dyndns.ws
• IP Cop Firewall // Router (192.168.1.1)
• Linksys AP (switch only)
• HP LaserJet 5SI NX (192.168.1.250)
• 1.8 TB Fileserver setup (Hivestore)
• XBMC Hooked up to projector, network, and fileserver.

Paul Reviewed this list as of 12/12/2010 - Is any of the below still relevant?

• The Westell modem has been connected directly to the Smoothwall firewall's external (red) interface via the patch panel. Port 69. Red cable.
• server01 (192.168.1.2) <-- Is this thing still alive?
• The Smoothwall has an internal (green) interface. This connects the firewall to the LAN. Yellow cable in port #2.
• The Linksys AP has been placed up on the wiring cabinet and connected, via one of its switch ports, to the LAN. Yellow cable in switch port #1.
• SSH access to server01 has been enabled via hive13.gotdns.org port 2222
• Server01 is running TFTP server for PXE boot

Work to be Done

• Install / configure netboot images on server01:
  • DBAN image
  • alternate *ubuntu images.
  • UBCD image
  • Parted Magic LiveCD image
  • Clonezilla image
•  ???
• [non-]profit

Hacklab

Hacklab is a dangerous, experimental portion of the Hive13 network. It is separate from the main network.