Small Laser Cutter: Difference between revisions

353 bytes added ,  14:57, 25 October 2018
Line 18: Line 18:


The Z-Datum is not working. You must manually set the Z height to 38 mm.
The Z-Datum is not working. You must manually set the Z height to 38 mm.
The controller has been updated to a Leetro 8530. The new operating panel is too large to fit in place of the old panel, so for now it is attached by a cord and operates like a game controller.
EasyCut2017 is installed on the Small Laser PC. It is much the same as EasyCUt 5.3 though you should plan some time to become acquainted with it's nuances.


Certified with the laser? Want to get on the good side of the laser operators? See what you can possibly do to help document and maintain the Laser!
Certified with the laser? Want to get on the good side of the laser operators? See what you can possibly do to help document and maintain the Laser!
528

edits