Delta 14" Bandsaw: Difference between revisions

75 bytes added ,  09:41, 14 October 2021
No edit summary
 
Line 15: Line 15:
==Blade change/Adjustment==
==Blade change/Adjustment==


#unplug the saw, remove the old blade.
#unplug the saw, use the knob on the top of the saw to relieve the tension on the blade, and remove the old blade.
#back off all guides and thrust bearings (two guides and a bearing above the table, two guides and a bearing below the table)
#back off all guides and thrust bearings (two guides and a bearing above the table, two guides and a bearing below the table)
#put the upper guide at mid height
#put the upper guide at mid height
Line 34: Line 34:
#adjust the upper blade guide to just above the thickness of the material you need to cut
#adjust the upper blade guide to just above the thickness of the material you need to cut
#plug in, and turn on the saw, check for rubbing, if sounds good, make a test cut to ensure everything looks good.
#plug in, and turn on the saw, check for rubbing, if sounds good, make a test cut to ensure everything looks good.


==Old mailing list post==
==Old mailing list post==
2,201

edits