To-Do List: Difference between revisions
Jump to navigation
Jump to search
(→To Do) |
(→To Do) |
||
| Line 2: | Line 2: | ||
= To Do = | = To Do = | ||
* Better exhaust for big and little laser cutters | * Better exhaust for big and little laser cutters | ||
* Some way to check the coolant water that doesn't involve climbing behind the big laser | * Some way to check the coolant water that doesn't involve climbing behind the big laser | ||
* Big laser cutter door lift improvement | * <s>Big laser cutter door lift improvement</s> | ||
* <s>Big laser pneumatic</s> | * <s>Big laser pneumatic</s> | ||
* <s>Pallet Racks in front of Fab Lab and Lounge</s> | * <s>Pallet Racks in front of Fab Lab and Lounge</s> | ||
Revision as of 21:11, 9 April 2018
This page is dedicated to general improvements to the space and/or existing tools. If you have suggestions, please list them here. If there are items on this list you think you can do, do them!! The hive is a do-ocracy after all!!
To Do
- Better exhaust for big and little laser cutters
- Some way to check the coolant water that doesn't involve climbing behind the big laser
Big laser cutter door lift improvementBig laser pneumaticPallet Racks in front of Fab Lab and LoungeCnc machine(s) cleaned off- Shapeoko set-up
- d
ust collector setup finishedbetter hanging methods needed
- steam clean carpet
finish gigabot upgrades- ge
t kegerator running again