|3D Printing||2D Cutting||Misc|
|List of All Documented Equipment|
|Hive13 Asset Tag: None|
|Make/Model: Ultimaker 2+ (Modified) (google)|
|Arrival Date: 11/21/2015|
|Does it work?: Yes|
|Certification Needed?: Yes|
|Contact: FabLab Warden|
Read through this page in its entirety before operating the Ultimaker. If this is your first time encountering an Ultimaker then I am excited for you. You're going to have a lot of fun! You should probably start by reading through Ultimaker's page for getting started with an Ultimaker.
Before you print
- It is usually more reliable to load your print onto an SD card and print from that SD card than to print over USB.
- If you need to load material, follow Ultimaker's instructions for loading and unloading filament.
What do I do if I screw something up?
If your print fails, abort it on the Ultimaker and then follow the build removal directions.
Remove the glass print bed from the machine before attempting to remove prints from the print bed. Allowing the print bed to cool completely should make removing prints easier. If they are still difficult to remove then use the largest pair of channel locks you can find and grip the print firmly. A simple twist should pop it off in one piece. You can also try heating the build plate from the back side with a heat gun. If you're going to scrape on the glass with a glass scraper always scrape away from you. Prints tend to come off suddenly and with little warning. If you don't follow these instructions your print will become exponentially more expensive, as it will involve a trip to the emergency room and stitches.
The Ultimaker 2 and Cura allow the use of almost any commercially available 3D printing filament with a nominal diameter of 2.85 mm. This is sometimes called 3 mm filament. If you use material from other manufacturers you will need to ensure the proper parameters are in Cura before printing. Printed Solid sells quality filament from Ultimaker, colorFabb, taulman3D, Proto-Pasta, and NinjaFlex. Filastruder sells filament from E3D including Edge, a high quality, easy to print CPE. Filastruder also sells taulman3D.
DO NOT USE ABRASIVE MATERIAL IN THE ULTIMAKER!
Hive13 would like to thank Lorin Parker, the University of Cincinnati Cognition Action Perception Lab and the Shroff Foundation. The Ultimaker 2 was purchased with a Shroff Foundation grant and was used between 2014 and 2016 for community education. It is now on loan from Lorin Parker.