To-Do List
Jump to navigation
Jump to search
This page is dedicated to general improvements to the space and/or existing tools. If you have suggestions, please list them here. If there are items on this list you think you can do, do them!! The hive is a do-ocracy after all!!
Contents
Hot Crafts Area
Jewelry & Metalsmithing
- Re-machine vice so jaws are square
- Add shelving around sink for tumblers and ultrasonic cleaner
- Add receiver hitch mount to bench for big vice, install vice on hitch mount
Stained Glass
Lampwork
- soft glass storage/organization - Currently have 55 soft glass colors, make holders for 80-100
- Replace wooden table support by kiln with a steel welded-in support
Ceramics
- Add vent hood over kiln
- Extend kiln downdraft vent fan cord to plug into vent hood plug
- pottery wheel: drip tray not secure, needs improvement
- Storage/Shelving
- Get rid of black shelves and put pottery wheel by column
- designate shelves work in progress and kiln ready
- consolidate ceramics stuff to wood shelves and make room for tumblers on green shelves
General Use and Other Equipment
- Ventilation
- Extend vent hood to over kiln and craft oven
- Add make-up air vent/duct to bring fresh air from north wall
- Table
- Replace pulled out screws, use 1/4-20 thread inserts to improve durability
- Add labels to table - "No Eating - Glass and Ceramic Dust Area"
- Add labels to stools - "Hot Crafts" (tops are 9" x 17.5")
- Craft oven
- Remove dryer receptacle/ 30-amp circuit
- Add 50 amp circuit for craft oven from Panel Z
- Drywall - finish corner with missing sheet
- Sink
- Add retractable spray faucet
- Rigidly mount sink back to wall and feet into floor
- Add shelves over sink (one suitable for holding the ultrasonic if possible, get rid of those black shelves that always become a mess)
- Replace overhead outlet with GFCI
Wiki/Documentation
- All ceramics area equipment (emphasis on basic process being documented)
- All jewelry bench equipment (bench tools and casting)
- All stained glass and slumping/fusing equipment/processes
3D Printing Area
- Resin Printer Prep
- Ventilation
- IPA & Other resin waste disposal
- Safety equipment
- Wash & Cure Station
- Filament Storage
- Tubs w/ airtight(ish) lids
- "Rechargeable" Desiccant (can be baked in ovens to release moisture it collects)
- Clearly marking spools of filament which type they are
Tools Needing TLC
| Tool | Location | Maintainer | Certification required? | Working? |
|---|---|---|---|---|
Located in;
Woodshop |
Is maintained by;
User:Reportingsjr |
Doesn't require certification
|
No
| |
Located in;
Ralph's House |
Is maintained by;
CNC area Warden |
Requires certification
|
No
| |
Located in;
Laser Bay |
Is maintained by;
Fab Lab area warden |
Requires certification
|
No
|
